Whirlpool Washer Repair
Top-load and front-load
Agitator and impeller machines with a drive system that fails at the coupler and the clutch rather than the motor.
- Drive couplers
- Clutches
- Lid switches
Washers, dryers, refrigeration, ranges and dishwashers.
Tell us the appliance and what it is doing. We will come and look.
Whirlpool builds refrigeration only, so this is the whole range — and each one links through to how that repair actually goes.
Top-load and front-load
Agitator and impeller machines with a drive system that fails at the coupler and the clutch rather than the motor.
Vented, gas and electric
The most widely serviced dryer here. Elements, fuses and belts, and all of them inexpensive.
Side-by-side and top-freezer
Conventional refrigeration with excellent parts availability, which makes most repairs worth doing.
Freestanding gas and electric
Mechanically simple and inexpensive to put right — usually worth repairing rather than replacing.
Front-control and integrated
Repeating faults and inexpensive parts, which keeps both the diagnosis and the bill short.
Single and double cavities
Widely serviced wall ovens where the clean cycle is the usual trigger for a blown fuse or a stuck lock.
What people call us about, and what each one usually turns out to be. Nothing is named as the fault until it has been proven at the part.
The most common call we take on any brand, and the cheapest to put right here: pump, filter or the standpipe at the wall, with parts on the van.
Top-load machines walk because the suspension pads under the tub wear flat. A set of pads costs very little and the machine stops moving.
On the top-load platform this is the lid switch nine times out of ten. It is a five-minute part and a frequent misdiagnosis.
Far more often the duct run than the heater, and lint builds in the run rather than in the filter.
Element, thermal fuse or gas valve, and all three are stocked. A blown fuse is still telling you the vent is restricted.
A belt, an idler pulley or a drum roller. Inexpensive wear parts and normally done on the visit.
A cabinet that drifts a few degrees and will not come back. Read against the sensor and put it on gauges before anything is named.
The defrost heater, timer or bimetal rather than the compressor. A fraction of the cost, and the symptom people most often misread.
A blocked defrost drain backing up into the cabinet. Clearing it is usually the whole repair.
Clicking means the spark is being made, so it is the electrode, a blocked port or a valve not opening.
A thermostat, a sensor or an offset. Checked against our own probe, not against the display that is part of the fault.
Heat protection doing its job. The power board is cooled by a fan and the fan is usually blocked, not the coil.
Plenty of shops will turn up. These are the parts of the job that decide whether the repair actually holds.
Sub-Zero, Viking, Wolf and Thermador are built differently from mass-market machines, and they fail differently. These are the units our techs are on every day, so the fault gets recognized rather than hunted for.
Parts and labor are covered for up to twelve months depending on the repair, and the term is written on your invoice rather than left vague.
Parts that match the original specification. A cheaper substitute in a sealed system is how a one-visit repair becomes three.
The visit costs $99. Go ahead with the repair on that same visit and the fee comes off the bill, so the diagnosis is effectively free. Decide not to, and you have paid $99 for a straight answer and owe nothing further.
You see the price and approve it first. No work starts, and nothing is ordered, until you have said yes.
Most calls across the Valley get a technician out the same day, and anything leaking or unsafe goes to the front of the run.
BHGS #50900 for Major Appliance Repair, independently confirmed by Yelp. Fully insured, so a mistake in your kitchen is our problem and not yours.
Floors protected, the unit back on its rails, and the packaging gone with us. A built-in has to come out before most repairs can start.
From the first call to the final test, every step is built around your time and your kitchen.
Call or send the form. Brand, model if you have it, and what the appliance is actually doing — that is usually enough to know what to bring.
A technician finds the fault and explains it in plain terms, including the parts involved and what it will cost.
Written, flat, and agreed before any work begins. If you would rather not go ahead, that is fine — you pay the call-out and nothing more.
Most repairs finish on the first visit. The work and the parts are warrantied, and we check back that it held.
We cover 53 cities and neighborhoods, from the Conejo Valley to Long Beach.
We cover 53 cities and neighborhoods across Los Angeles and the Conejo Valley, from the Conejo Valley to Long Beach.
“This company is fantastic. Art worked tirelessly on my SubZero. We had multiple problems and he came out every time that I called him. They are reliable, honest, and quick. Thank you Art and Victor!”
“I am a property manager in LA County with multiple properties. MKH Appliance Repair is my go-to solution for all things appliance related. They have been helping me get repairs done quickly for the past 2-3 years. I cannot thank them enough for the quality service they provide! If you need your appliances fixed, call them!!…”
“… The Appliance Repairman arrived promptly and was incredibly professional and knowledgeable. He diagnosed the problem with my refrigerator quickly and explained the repair process clearly. The repair was done efficiently, and my appliance is now functioning perfectly. Their customer service was outstanding from start to finish.…”
The things people ask us most, answered plainly. If yours is not here, phone and ask.
(213) 523-3555Tell us the brand and what it is doing. Most repairs finish on the first visit, and you will know the price before any work starts.