Frigidaire Refrigerator Repair
Side-by-side, French-door and counter-depth
Conventional refrigeration in volume. Defrost circuits and door seals are most of the work and the parts are inexpensive.
- Defrost circuits
- Evaporator fans
- Door seals
Refrigeration, ranges, dishwashers and laundry in volume.
Tell us the appliance and what it is doing. We will come and look.
Frigidaire builds refrigeration only, so this is the whole range — and each one links through to how that repair actually goes.
Side-by-side, French-door and counter-depth
Conventional refrigeration in volume. Defrost circuits and door seals are most of the work and the parts are inexpensive.
Freestanding gas and electric
Simple, serviceable cooking hardware with repeating faults — usually a same-visit repair.
Front-control and integrated
Drainage and the inlet circuit account for most complaints, and both are inexpensive to put right.
Front-load and top-load
Volume machines with familiar faults: pumps, door switches and the control board.
Vented, gas and electric
Elements, fuses and belts. A blown thermal fuse is usually reporting a restricted vent rather than failing on its own.
Upright and chest
Secondary freezers, frequently in a garage, where condenser load is the story rather than a failed component.
What people call us about, and what each one usually turns out to be. Nothing is named as the fault until it has been proven at the part.
Volume refrigeration with a conventional sealed system. The faults repeat across whole buildings, so we usually know the answer before arriving.
Defrost timer or heater. On these the timer is mechanical on older units and a board on newer ones, and the two are diagnosed differently.
A blocked defrost drain backing up into the cabinet. Clearing it is usually the whole repair.
Clicking means the spark is being made, so it is the electrode, a blocked port or a valve not opening.
A thermostat, a sensor or an offset. Checked against our own probe, not against the display that is part of the fault.
Heat protection doing its job. The power board is cooled by a fan and the fan is usually blocked, not the coil.
The drain pump, the filter, or the air gap at the sink — and often the last of those, which is not the dishwasher at all.
Spray arms and the filter, and on these the filter is the one nobody has lifted out since the machine was installed. Often cleared without a part at all.
The cabinet panel is screwed to the door and the hinge springs were balanced for that weight once.
Pump and filter, and the parts cost very little. One of the repairs where the call-out is the larger half of the bill.
Suspension rods or dampers, or the balance sensor letting it spin an uneven load. Worth fixing fast upstairs.
The door lock assembly or a pressure switch, not the motor. Both are inexpensive and usually same-visit.
Plenty of shops will turn up. These are the parts of the job that decide whether the repair actually holds.
Sub-Zero, Viking, Wolf and Thermador are built differently from mass-market machines, and they fail differently. These are the units our techs are on every day, so the fault gets recognized rather than hunted for.
Parts and labor are covered for up to twelve months depending on the repair, and the term is written on your invoice rather than left vague.
Parts that match the original specification. A cheaper substitute in a sealed system is how a one-visit repair becomes three.
The visit costs $99. Go ahead with the repair on that same visit and the fee comes off the bill, so the diagnosis is effectively free. Decide not to, and you have paid $99 for a straight answer and owe nothing further.
You see the price and approve it first. No work starts, and nothing is ordered, until you have said yes.
Most calls across the Valley get a technician out the same day, and anything leaking or unsafe goes to the front of the run.
BHGS #50900 for Major Appliance Repair, independently confirmed by Yelp. Fully insured, so a mistake in your kitchen is our problem and not yours.
Floors protected, the unit back on its rails, and the packaging gone with us. A built-in has to come out before most repairs can start.
From the first call to the final test, every step is built around your time and your kitchen.
Call or send the form. Brand, model if you have it, and what the appliance is actually doing — that is usually enough to know what to bring.
A technician finds the fault and explains it in plain terms, including the parts involved and what it will cost.
Written, flat, and agreed before any work begins. If you would rather not go ahead, that is fine — you pay the call-out and nothing more.
Most repairs finish on the first visit. The work and the parts are warrantied, and we check back that it held.
We cover 53 cities and neighborhoods, from the Conejo Valley to Long Beach.
We cover 53 cities and neighborhoods across Los Angeles and the Conejo Valley, from the Conejo Valley to Long Beach.
“This company is fantastic. Art worked tirelessly on my SubZero. We had multiple problems and he came out every time that I called him. They are reliable, honest, and quick. Thank you Art and Victor!”
“I am a property manager in LA County with multiple properties. MKH Appliance Repair is my go-to solution for all things appliance related. They have been helping me get repairs done quickly for the past 2-3 years. I cannot thank them enough for the quality service they provide! If you need your appliances fixed, call them!!…”
“… The Appliance Repairman arrived promptly and was incredibly professional and knowledgeable. He diagnosed the problem with my refrigerator quickly and explained the repair process clearly. The repair was done efficiently, and my appliance is now functioning perfectly. Their customer service was outstanding from start to finish.…”
The things people ask us most, answered plainly. If yours is not here, phone and ask.
(213) 523-3555Tell us the brand and what it is doing. Most repairs finish on the first visit, and you will know the price before any work starts.